tilt up walls
INSUL-DECK Lightweight and fast leave-in-place EPS Concrete forms for floors, roofs and walls.
Concrete Floors concrete forming system Home Concrete Floors Insul-Deck Concrete Floor TILT-DECK tilt up concrete forms Concrete Floors Residential Concrete Floors Commercial Concrete Floors Concrete Floor
Concrete Roofs Concrete Roofs Concrete Floors Distributors and Sales Representatives concrete forms News concrete forms Contact insulated concrete forms Concrete Roof Concrete Roofs
concrete construction
 


 

 

2006/2007 Tax Credit InformationLearn How

 

Satisfied Insul-Deck Homeowner/Builder:

Las Vegas, Nevada
23,000 Sq. Ft.; 40' Foot Span
Owner/General Contractor: Warren Certain

Long Spans for Large Open Areas


Insul-Deck is the fast, lightweight, forming-system solution for concrete floor and roof construction. It comes pre-engineered, pre-cut, prelabeled and staged for quick and easy placement on site. The new home owner/builder, Warren Certain, was quoted as saying, “I think the product is awesome! We actually saved a ton of money and time.”

Insul-Deck is the fast, flexible and safe method to build a concrete floor or roof that saves labor, time and money. Experienced crews are installing panels and rebar support and pouring concrete in one minute per square foot.

Any type of interior finish can quickly be mechanically attached to the integral steel furring strips with drywall screws. Insul-Deck is faster form-to-finish per square foot than any other process.

Insul-Deck’s patented process integrates utility chases (2) within the forming system. Utilities are easier to install in pre-molded access chases (or channels). Insul-Deck’s patented process produces self-supporting, steel beams and furring strips molded into the ceiling. Insul-Deck offers a variety of insulation and roof or floor thicknesses. Form depths up to 12-1/2" produce deeper supporting ribs, which allow spans up to 30 feet (3).

For Insul-Deck you only have three steps: place, pour and finish. For pre-cast and pan and deck, you need a crane and/or have to remove the forms. With Insul-Deck: you pour it, you finish it - you can take it to the bank.

 

Insul-Deck is a registered trademark of Insul-Deck LLC.

Shoring & Bracing: Installer is responsible for the design and correct installation of Shoring of Insul-Deck forms in accordance with the ACI (American Concrete Institute) 347-03 “Guide to Formwork for Concrete” or current applicable codes. Any variance from those standards must be provided and certified in advance by a Structural Engineer, licensed for the job site location and specifications.
Reinforced Concrete: Installer is responsible for placement of all reinforcing steel in accordance with the ACI (American Concrete Institute) 318-02 “Building Code Requirements for Structural Concrete” or current applicable codes. Any variance from those standards must be provided and certified in advance by a Structural Engineer, licensed for the job site location and specifications.

 

 
 

INSUL-DECK, LLC
935 Main Street
Suite A2
Safety Harbor, FL 34695

Phone: 800-475-6720
Fax: 727-216-7946
Email: insuldeck@tilt-deck.com
Web: www.insul-deck.org
 



E-commerce solutions by Lohre & Associates