Tilt-Deck Project Completed:
|
Southern, Ohio
130,000 Sq. Ft.; Heights up to 21 feet
Contractor: Major Tilt-Up Contractor
Join the revolution to faster tilt-up construction
|
 |
A crew installs a tilt-up concrete wall for the fourth and final phase of medical office condominiums the 75-acre, $100 million mixed-use campus. Started in 2001, the project began with a 80,000-square-foot medical facility and has grown to include 130,000 square feet of additional medical offices and retail uses. The new 29,000-square-foot, one-story office building can be subdivided into up to eight medical office condos. |
 |
Tilt-Deck
speeds forming and saves time and money. Tilt-Deck
is the lightweight forming system solution for concrete
tilt-up construction. Tilt-Deck comes pre-engineered,
pre-cut, pre-labeled and staged for quick and easy
placement on site. |
 |
Tilt-Deck
is the fast, flexible and safe method to build a
concrete tilt-up wall that saves labor, time and
money. The contractor saved nearly two weeks building
this outpatient facility by using Tilt-Deck’s
forming system for his “single point face lift”
tilt-up construction. Experienced crews install
panels and rebar support and pour concrete in one
minute per square foot. |
 |
Tilt-Deck
offers a variety of insulation and wall thicknesses
for tilt-up construction. Form depths up to 12-1/2"
produce deeper supporting ribs that allow heights
up to 30 feet. The Expanded Polystyrene material
also has excellent insulating properties. |
 |
Tilt-Deck’s
Patented Process Integrates Utility Chases within
the forming system. Utilities are easier to install
in pre-molded access chases (or channels). The Expanded
Polystyrene can be easily removed, if needed, to
allow for larger utility runs. |
 |
Tilt-Deck’s
patented process produces self-supporting steel
beams and furring strips molded into the wall. Any
type of interior finish can quickly be mechanically
attached to the integral steel furring strips with
drywall screws. |
 |
Faster form-to-finish per square foot than any other form process. For Tilt-Deck you only have four steps: place, pour, tilt and finish. With Tilt-Deck: you pour it, you tilt-it, you finish it - you can take it to the bank.
|
|
Tilt-Deck is an exclusive product of Insul-Deck, LLC
Insul-Deck and Tilt-Deck are registered trademarks of Insul-Deck LLC. |
Illustrations show typical, generic layout and finishing styles. They are not intended as a guide for structural engineering or to reflect specific construction practices. |
Shoring & Bracing: Installer is responsible for the design and correct installation of Shoring of Insul-Deck forms in accordance with the ACI (American Concrete Institute) 347-04 “Guide to Formwork for Concrete” or current applicable codes. Any variance from those standards must be provided and certified in advance by a Structural Engineer, licensed for the job site location and specifications. |
Reinforced Concrete: Installer is responsible for placement of all reinforcing steel in accordance with the ACI (American Concrete Institute) 318-05 “Building Code Requirements for Structural Concrete” or current applicable codes. Any variance from those standards must be provided and certified in advance by a Structural Engineer, licensed for the job site location and specifications. |
